Recent content by andressavannah

ok, thanks!!

Yes but: position 1 (full): mismatch, the amp output of 16 ohms connected to (bypass) the 8 ohm cab, position middle and low of the switch is ok, it is correct?

Thanks!. My amp is a custom hand made tube 50 watts amp. This amp has 3 outputs, 4, 8 and 16 ohms, but the cabinet is 8 ohms. The manufacturer of the amp said to me that should be no problem is I use the 16 ohm load in the 8 ohm output.

I purchased the Captor x 16 ohms, but my 50W tube amp 8 ohms and my cab is 8 ohms, is there any issue with the use of the Capto x 16?