Recent content by GerryJ

  1. G

    How Old are Ya Guys?

    Rather than "how old", maybe it should be "how deaf" ;).
  2. G

    If You Could Resurrect an Old Amp Manufacturer??

    Pearce.....never tried one, but Steve Khan (clean jazz guitarist) recorded many times and the sound was stunning. Solid state.
  3. G

    So I have 4 Boss SD-1’s

    I have a Boss bluesdriver with the Keeley mod, sounds good. Does that get me in the same general neighborhood as the SD-1 (never tried one)? Thanks.
  4. G

    Pop noise when turning on or off stanby

    Does the amp pop if it's plugged into a separate outlet & used by itself, no 2nd amp, no pedalboard? If not, then as mentioned above it could be a ground loop issue.
  5. G

    Load impedance question

    Your 4x12 dry, stereo 2x12s wet setup- do you play out with that?
  6. G

    BLIND TEST! Friedman vs Axe Fx III vs Helix...

    My impression too. All 3 certainly sound good enough to be interchangeable for recording. Btw, is that the main purpose here? ...to demonstrate that software/DAW can essentially duplicate the signal chains of the 70s & 80s recording studios at < 1% of the cost? Absolutely. Can software...
  7. G

    Best sounding current production EL34, what are you guys using ?

    Thanks....I have a YBA-1 bassmaster, which doesn't have an adjustable bias pot, but Tesla EL-34s do fine when tested (with a bias probe device), drawing 32 mA and sounding fine. So I leave that amp completely stock. The YBA-1A Mk II bassmaster is the one I'm more concerned with, as it has higher...
  8. G

    Best sounding current production EL34, what are you guys using ?

    Hello (first post here) - I've got some 70s era Traynor Bassmasters- they were originally fitted with GE 6CA7s (they were current production back then!). Most recently, been using Tesla EL34s, which seem to do OK in the ~ 45 watt YBA-1 bassmaster (2 power tubes, screen and plate voltages ~ 427...
Back
Top