EddyLenz
Well-known member
Hey Guys,
I received this amp to add a tube FX loop and it ended up being a bit more work than that.
For some reason, the power transformer had been replaced in the past and the work was done extremely poorly.
The transformer also didn't seem to be that good, so we decided on swapping it for a new one.
There were also two replaced tube sockets that were in very bad shape, which I had to replace again.
Since I knew that the amp would be used with a Mr. Scary mod, I cleaned up the preamp heaters to reduce noise and added shielded grids on V1.
I also cleaned up some of the other wiring to reduce noise and crosstalk.
Here's the amp with the new FX loop
I received this amp to add a tube FX loop and it ended up being a bit more work than that.
For some reason, the power transformer had been replaced in the past and the work was done extremely poorly.
The transformer also didn't seem to be that good, so we decided on swapping it for a new one.
There were also two replaced tube sockets that were in very bad shape, which I had to replace again.
Since I knew that the amp would be used with a Mr. Scary mod, I cleaned up the preamp heaters to reduce noise and added shielded grids on V1.
I also cleaned up some of the other wiring to reduce noise and crosstalk.
Here's the amp with the new FX loop