jaybird
New member
Hi guys,
Been a long while since I posted but could use some help. I had a output tube go bad in my modded Marshall 1959. Blew both the fuses. I replaced the fuses and all the tubes - both pre and power, but it's not working. In standby I see the tubes are glowing from the heaters, but dead silence when switching out of standby and no other visible change on the output tubes. I put my Weber Bias rite in, and reading all 0.0's for plate voltage, current, etc.
Any ideas as to what to look at next?
Thanks!
Jason
Been a long while since I posted but could use some help. I had a output tube go bad in my modded Marshall 1959. Blew both the fuses. I replaced the fuses and all the tubes - both pre and power, but it's not working. In standby I see the tubes are glowing from the heaters, but dead silence when switching out of standby and no other visible change on the output tubes. I put my Weber Bias rite in, and reading all 0.0's for plate voltage, current, etc.
Any ideas as to what to look at next?
Thanks!
Jason