Help needed! How to use footswitch with ENGL Savage SE amp?

Ewido

New member
Hi there. I'm new in here.
I have an ENGL Savage Special Edition.
I also have an ENGL Z-7 midi interface and an ENGL Z-12 midi controller.

I have read all three manuals - but I can still not figure out how to program just the simplest of presets.

Can anyone help me?

Thanks
 
I use exactly the same setup. It's super easy and straightforward.
Set the Z-7 to omni mode -> choose the bank/location on Z-12 where you want to save the preset -> set the amp the way you want -> hold Write/Edit button on Z-7 for roughly 3 seconds (the red LED will flash and then stop) ... and you're good to go

Example: select location 01 -> select clean channel, Presence A, Master B and reverb active -> hold Write/Edit button and voila there you have your clean setting
select location 02 -> select lead channel, Presence A, Master A (everything else off) -> hold Write/Edit and there is your metal rhythm setting
 
Perfect, thanks! I will try that. I always pressed the up and down switches simultaneously to activate the midi in the pedal. So nothing worked.
You explanation is so much easier than anything in the manual! :)
 
Back
Top