ElectricTurkey4369
New member
I'm running a pair of Scumback M75's @ both at 16ohms. I had the cab in my trunk a few days ago and forgot it was in there. It tipped over and fell flat onto the front side while I was driving. The other speaker sounds fine, but the other sounds like there's internal rattling going on, even at the lowest volumes.
My amplifier is a Matrix GT1000/Axe FX II. The speakers are in a Port city 212 with a Stereo/Mono switch. I run stereo into to two 8ohm inputs on the cab. With one cable plugged into the good speaker i still hear the rattling/buzzing/distortion of the other speaker.
I keep the matirx A/B levels at noon. I am wondering if maybe i pushed the level too far while trying to find a balance between the Axe out put and the matrix. but never have I turned A/B past 3 o'clock, and I'm always attentive of the signal light when it flashes.
My amplifier is a Matrix GT1000/Axe FX II. The speakers are in a Port city 212 with a Stereo/Mono switch. I run stereo into to two 8ohm inputs on the cab. With one cable plugged into the good speaker i still hear the rattling/buzzing/distortion of the other speaker.
I keep the matirx A/B levels at noon. I am wondering if maybe i pushed the level too far while trying to find a balance between the Axe out put and the matrix. but never have I turned A/B past 3 o'clock, and I'm always attentive of the signal light when it flashes.