4x12 Cabinet wiring

[Dale B]

All right... I just got some of those Pre-Rola Weber Clones and they're rated a 16 ohms. I just put them in my Bogner Uberkabinet. I swapped them out one at a time and soldered everything back to where it was before, but now I'm second guessing myself.

I know where two wires from the input jack connect. That's not the problem.

Now, here is what I have right now:

Left Side

Top Speaker:

Positive is connected to the Negative of the Top Right Speaker
Negative is connected to positive of Bottom Left Speaker

Bottom Speaker:

Positive is connected to the Negative of the Top Right Speaker
Negative is connected to the Negative of the Bottom Right Speaker


Right Side:

Top Right Speaker:

Negative is connected to the Positive of the Top Left Speaker
Positive is connected to the Positive of the Bottom Right speaker

Bottom Right Speaker:

Positive is connected to the Positive of the Top Right Speaker
Negative is connected to the Negative of the Bottome Left Speaker


It just seems weird when I compare this to other wiring diagrams. For some odd reason, I think I need to change the Bottom Right Speaker's wiring around. There would be Negative/Positive connections throughout the cabinet then.


HELP!!!

 

[Dale B]

Ok....... I drew some pictures:

My Wiring:

How I think it should be wired:

 

[Dale B]

I need a 16 ohm load.

 

[Dale B]

I think I have it now:

Which would be:

 

[Marshall Freak]

I got this off of celestions site.

 

[Dale B]

I got this off of celestions site.

I think that's what I just got. I just soldered it that way.

 

[Dale B]

I fired it up a little while ago and it worked. These speakers sound awesome!