Anyone using a Mod 100 or Mod 50 with a TC G System?

  • Thread starter Thread starter ratkent
  • Start date Start date
LOL, me too... still have the LLS, if anyone's interested, pm me :)
 
Chris R":3ikbu2rv said:
LOL, me too... still have the LLS, if anyone's interested, pm me :)
Me too but holding on to it . :lol: :LOL:

<----- My G system ;) The rack....G what a system.. :lol: :LOL:
 
I've already been using the G System with great results. I'm just looking for anyone who is using one with the Egnater Mod series to see if I need to change any of the levels or input/output settings if I switch amps.
 
Its a great unit, if I played out I would have kept it. You will need an Ebtech LLS. Not really sure if you will need to tweak it, I dont see why you should but I do Know the "Slave Out" is running hotter than most amps and needs a resister soldered inline on the out cable.
 
Just used my new to me Nova System with my Mod50, and it was like "heaven"...even though I saw a G System for really cheap on another forum, I didn't wan to go through the ordeal of dealing with a Line Level Shifter all over again.

Bought it when the Mod50's Loops were overpowering the inputs of my delay pedal. And I sucked the life off my Mod50, pulled it from my pedalboard on a soundcheck about half an hour before the show, played that show without a delay.

It is evident TC committed a hardware error with the G-System, because they know about the problem, and haven't dealt with it on any of the updates...but still they release the Nova System with a designated Line level input for use on the FX loop of an amp.
 
The G System is not Line level? I use pedals with my Mod 50 and it does not suck away life. The Ebtech line level shifter handles this perfectly!!!!

That said, I am planning to get a TC Nova with my Rebel 30.
 
richedie":14ghtu0t said:
The G System is not Line level?
That was exactly my question...but the answer is, If you need a LLS to work in the loop of a Mod50...well the it isn't line level. Kinda sucks!!!
 
Back
Top