HerbieBoogie
Active member
does anyone know if the Behringer FCB1010 Midi Foot Controller is good for changing the channels on the Herbert.
steve_k
New member
HerbieBoogie":34d8jbb3 said:
I think quite a few around here use that pedal. Any MIDI pedal will do.
Steve
Peter Diezel
Well-known member
I had a FCB and with the factory setting it didn´t work from the start.
You will need a manual.
You will need a manual.
B
Bato
New member
It´s easy.
You´ll need to put a preset number to each preset on the fcb.
f.e. Bank 0 switch 1 = 1, 2=2, ....
Bank 1 switch 1 = 6, 2 = 7, etc.
Now Herbert can use every preset and you must store every Amp channle setting at the chosen preset.
You´ll need to put a preset number to each preset on the fcb.
f.e. Bank 0 switch 1 = 1, 2=2, ....
Bank 1 switch 1 = 6, 2 = 7, etc.
Now Herbert can use every preset and you must store every Amp channle setting at the chosen preset.