Changing speaker on my 2x12 Marshall JCM2000 TSLC212

  • Thread starter Thread starter diezel&gas
  • Start date Start date
diezel&gas

diezel&gas

Member
hi, i'd like to try a Celestion G12K100 to pair with the other stock 12" V30 on my marshall 2x12 cab.

stock this cab has: a Marshall/Celestion Heritage 12", 8 Ohm, 80W guitar speaker and one Marshall/Celestion Vintage 12", 8 Ohm, 70W guitar speaker.

http://www.musik-produktiv.de/(s(opo0xi ... blhilg3cav))/marshall-jcm2000-tslc212.aspx


how many Watts will the cab reach with the V30 and G12K100 mixed? willl the Ohms change?
actually it can handle 140W in 16 Ohm.

then is it a difficult thing to do swapping speaker? i mean, is the soldering hard to do?

thanx!
 
Soldering is easy. Just two wires. You need to look before unsoldering the old speaker which wire is hooked to plus and minus of it and follow that order for the new speaker.

The max. power of a cab is number of speakers multiplied with the wattage of the weakest speaker. In your case 2x70 Watt.

Get an 8 Ohm speaker if the old ones have 8 Ohms. Overall impedance then is 16.
 










the speaker that i'll change is the one on the right of the cab - the heritage
 
maybe there is nothing to solder... speaker's got quick connect plugs...
 
Yup, pull the clips off, unscrew the old speaker, put the new speaker in, and put the clips on... voila! Going to sound fantastic BTW, that's a very good mix.


Nick
 
Yes it'll be ;) I just have to find a good offer for it now
Thanx
 
? ??

then, another question;

Peter S. told me is is better to replace stock Marshall wiring with another-better specific leads for the g12k cause of different frequencies this speakers provide and needs.
Which cables are those mentioned by Peter?
 
Hi, I never had the chance to swap the Heritage speaker with the Gk100, so would you suggest me to pair it with the v30?
Will I get a better tone in your opinion getting the Gk100 or will I get a flat, similar tone as the v30?
 
You must log in or register to reply here.
Back
Top