Density & Prescense Knobs

[dieselmx]

Having so many tone options on the renegade I forgot all about the density and prescence knobs .. I was playing in practice with them all the way down...

I will have to try again with them up and see what kinds of tone difference there is ...

do many of you use these? im sure this will make a big difference in tone. ... ugh.. im slow. haha.

 

[hisclimb]

Pretty significant features...

The density changes the low end response. Adding more density loosens the low end creating more roundness, or woodiness to the tone in my opinion. I usually set it near 12 o'clock.

Presence adds top end sizzle. It makes things stand out a little more and adds high end bite. I set this anywhere from around 11-2 o'clock depending on the gig and the room.

You might find as volume goes up, you need to turn the density down a little as too much density at high volume can be tough on the speakers since it loosens the bottom end.

 

[hbucker]

I tend to like them set higher as my volume drops. Lower as I get louder.

Your results may vary.

 

[Len Rabinowitz]

I find them pretty subtle on the Tourmaster. I keep them off at high volumes, up a bit at low. Should use them sparingly.

 

[Anonymous]

I tend to like them set higher as my volume drops. Lower as I get louder.

Your results may vary.

+1

my tourmaster density is touchy, the presence doesn't seem to do too much until around 5oclock, then it's really noticeable all the sudden. need a mod for that!

 

[Len Rabinowitz]

They are not an ear candy effect. Some sparkle on the high end and some fullness on the lows.