Diezel footswitch operation (Herbert)

[strata2628]

can anyone tell me if you can split the XLR feed to/from the footswitch to run settings on 2 heads? It is the older/rare switch built for switching channels on the Herbert/VH4(s). It has an XLR connection (I am using) but is buss-powered so, I am concerned about splitting the signal and having it run into trouble receiving/sending to more than one head @ a time. I guess the primary concern would be that it would be over-powered and thus be a problem. Any advice would be awesome, thanks.

 

[John4021]

...switching TWO Herberts
What about using the MIDI out on the pedal.
I'm not sure if I understand what your trying to do

 

[Peter Diezel]

Did you try to connect the second head midi in
with the first amp midi thru ?

 

[strata2628]

I was just curious if switching 2 Herberts' simultaneously * w/the foot-switch was possible without doing damage to the switch or the amps' control wiring, etc.
I'd rather not get into midi (why i didn't opt for a Columbus) I like the xlr connection to switch channels/mid-cut, loop, etc on the head(s).

*e.g.: switching both heads' to channel "2", or switching both heads' mid-cut at the same time.

 

[Peter Diezel]

Just do it like Reza said !!!

 

[PaulyPanacea]

Like Reza said. I did it this way. Worked flawlessly

 

[strata2628]

cool. thanks guys