ttosh
New member
Reviewing the information in the manual there is not a line out for the Herbert. Is an ISO box from Suhr going to be the best option for this?
G
geetar_geek79
Member
you can use your parallel efx loop send like a line out if you're not using it for anything. i imagine it should be free of efx since you're wanting to do a wet/dry setup.
moltenmetalburn
Active member
I do this with my Einstein.
ttosh
New member
Is the Send of the loop after the pre section? I have always ran my Wet with a line out after the power section. I wonder how this would sound doing it this way? I will have to give it a shot and see what comes out 
moltenmetalburn
Active member
ttosh":1b9eeu2a said:Is the Send of the loop after the pre section? I have always ran my Wet with a line out after the power section. I wonder how this would sound doing it this way? I will have to give it a shot and see what comes out
correct after the preamp.
i should have mentioned Im using a tube power amp not a SS full range so it works well for me, not identical tones but that was whats I wanted, using different output tubes for each.
if doing the SS thing the suhr iso is your best bet for the post power amp signal.
MARK2C
Member
How about the compensated out ?
moltenmetalburn
Active member
MARK2C":87gyta9f said:
Includes speaker simulation.
I didnt do it this way because I didn't want to double up on the speaker EQ curve.