Egnater M4 and G system

[drew3green]

Hey guys ok here we go again.

Hooked up the g system to the M4 via G insert send to M4 input, M4 out to g return, G out to Randall RT2x50.

Now I have no use of my moduals I only get one clean tone no matter what channel I am on! I've used Lairds white paper and assume maybe it has to do with the fact I am not yet using balaced cable, or and ebtech line level selector but the volume level seems ok just no moduals are accesable? Could it be a setting I am missing? I've used Lairds White paper, but still am having no luck.

Can any one help me with this?

Thanks all
Drew

 

[jmgman69]

Do you have the insert lock on,I run this same setup and don't need n Ebtech,just a little learning curve ans balancing act.

 

[Chris R]

Hey Drew,

Just pm'ed you. Check that the Insert Lock is set to on.

-Chris

 

[drew3green]

That was it guys thanks the lock was on but not the loop itself. Sorry for the hassle this thing takes a bit of getting used to. Really appreciate it.

Drew

 

[jmgman69]

That was it guys thanks the lock was on but not the loop itself. Sorry for the hassle this thing takes a bit of getting used to. Really appreciate it.

Drew

 

[oshuwah]

I'm running an M4 + G-System as well and boy was it frustrating to get to work (because of the G-System). Could never have done it with out Laird's help. I've only been using it for a few months now and am taking baby steps with my presets on the G-System just to make sure I do not get in over my head.