flycase for the Herbert

  • Thread starter Thread starter diezel&gas
  • Start date Start date
diezel&gas

diezel&gas

Member
hello i'd need something to carry the amp to rehearsal with me..

from the thomann site there are these 2 i see..one is an amp head flycase, the other is an accessories flycase.

https://www.thomann.de/it/thon_haubencas ... 0b39d4a2e0

https://www.thomann.de/it/thon_zubehoerc ... 0b39d4a2e0

one is a little expensive, the other is cheaper but less strong, built with thinner stuff.

they told me the 2nd suits my needs the same but the 1st is obviously sturder.

what do you think? the herbert is 27 kg. circa.... the case must resist just the transport from my car to the rehearsal room...few meters :P not that much stress, but i don't want to see my herbert falling on the ground by a whole inside the case :cry:

thanx
 
i would say take the first one - almost everybody i know owns this one and it fits your need. (i will receive almost the same end of this week :D )

remember also that at the second one you always have to lift the amp out - at the first one you can just open the case and take the case-cover away.
 
i think the one from musicstore is little bit MORE solid.

i ordered this one:
http://ssl.tsx-cases.de/haubencase-fuer ... -1055.html

this is 7mm wood instead of 9,5 mm wood as far as i can see, but the rest is the same. i don't think that this makes THAT difference as 7mm is already realy solid, and also the second case you mentioned is also 7mm - BUT - as far as i can see its to big for the amp and it will slide around during trnasportation.
 
i'm taking measurements on my herbert....i found a flight case constuctor in my city.

from the diezel site i read they are : 74x29x28 cm


i got:

lenght 74 cm. circa
width is 28 cm. circa
height 27 cm. circa foot and handle included.

which measure need to have more room on the case?


right?
 
You must log in or register to reply here.
Back
Top