Gone

  • Thread starter Thread starter splawner
  • Start date Start date

To buy, sell, or trade in this section, you must have at least 50 posts and have two-factor authentication enabled.

Looking to sell my Monomyth modded mojotone 50 watt head. Amp has a low and high input. Low input has tons of gain and high has an extra stage for more gain. Amp sounds amazing. Has a metro loop with level control. Has the thunder control on back. Sounds great at very low volumes. Just biased with a fresh set of Tung Sol power tubes.
 
Last edited:
LP Freak said:
What a steal!
Click to expand...
For sure, for this price and how good this amp sounds it’s kinda silly. I always wanted to try one and I lives up to everything I heard in every clip. Everything about this amp is solid from parts used components and all. I have been playing my boosted 800 for 2 years now which I feel is the best tone out there and this is as close you can get which is the reason I’m letting it go. Some one will be super happy without breaking the bank.
 
I need this like a hole in the head but I've been curious about these lately and this looks pretty clean. Any gut pics by chance?
 
IS350xtrm said:
I need this like a hole in the head but I've been curious about these lately and this looks pretty clean. Any gut pics by chance?
Click to expand...
Most guys aren’t too happy when you post pictures of their work
 
IS350xtrm said:
I need this like a hole in the head but I've been curious about these lately and this looks pretty clean. Any gut pics by chance?
Click to expand...
Out of respect for Monomyth amps I would not post them here but I can tell you that it’s impressive. The work inside is all quality caps and resisters and the work is a clean as it gets!
 
Fair enough. Not my intention to ruffle any feathers. As a guy who does very technical work (albeit with robotics and automation) I base a lot of my opinion of the quality of work on the care taken to perform it. Manufacturers have fairly standard ways of doing things. Small builders and modders are all over the place. I'll look elsewhere. Thanks though.
 
IS350xtrm said:
Fair enough. Not my intention to ruffle any feathers. As a guy who does very technical work (albeit with robotics and automation) I base a lot of my opinion of the quality of work on the care taken to perform it. Manufacturers have fairly standard ways of doing things. Small builders and modders are all over the place. I'll look elsewhere. Thanks though.
Click to expand...
Cool story, bruh. I’m fairly certain Shea’s work would pass your stringent standards. :thumbsup:
 
Last edited:
I was in, its as nice as any out there. Turret board with quality components. Classic tone output tranny and choke. Good stuff, for the price it’s a steal. bad ass gain monster. Surprisingly quiet and tight. It’s a plug and play amp.
 
You must log in or register to reply here.
Back
Top