Ground control pro and Slave? Anyone in Daves shop

  • Thread starter Thread starter jlbaxe
  • Start date Start date
jlbaxe

jlbaxe

Banned
Active member
Hello Dave,

Quick question. I have a Ground control pro and 2 gcx's. The first GCX has 2 Egnater M4's and a mod50 in the first 3 loops, loop 6 7 and 8 used for bypassing 3 effects. the 2nd GCX has 4 rack effects (TC2290 1210 spacial, BK tube driver, Dual Rat R2DU,Digitech 33B IPS, Digitech RPM-1) and 3 pedals GE7,BK tube driver Maxon OD808. I was wandering if I can run a second GCP as a slave (instant access) so I can punch in/out effects on the fly but still have the master control the entire rig. If I decided to add or remove an effect for whatever reason I could simply. A quick shot of the rig, wiring will be done after its set up and running then I can go back and use mogami/switchcraft. Thanks for your time I know your busy.
 

Attachments

  • Rig 6 19 09 A.JPG
    Rig 6 19 09 A.JPG
    1.3 MB · Views: 873
You know I have never tried I would suggest you go over to the new voodoo lab forum and ask them. I think it is doable.
 
Thank You. I sent them an email. I will post here there response .
 
They think it might work but no one is sure. Id go with an Axess fx1 and expander but they seem to be out of commission for awhile. Also with the Axess I could do instant access on more than one GCX. :D
 
jlbaxe":tp3x1beg said:
They think it might work but no one is sure. Id go with an Axess fx1 and expander but they seem to be out of commission for awhile. Also with the Axess I could do instant access on more than one GCX. :D
Click to expand...

How about the Liquid Foot controller? I think that might be able to do what you want.
 
I'm checking that out. I sent them an email with some questions. Would be great if it does. I didn't see an expansion board option.
 
You must log in or register to reply here.
Back
Top