SQUAREHEAD
Well-known member
It's never happened to me before but I was switching between Variac and regular mode and I blew one of the little small fuses connected to the power tubes… The amplifier powers up right now but no sound… The value of this fuse is 250 V 500 mA, is it OK to use a 250 V 1A fuse?!
This is all I can find anywhere
Shouldn't the amp work properly just with two power tubes, another words each fuse is connected to a pair of the output tubes… The amplifier should still work just at 50 W correct?
But I get no sound at all…
This is all I can find anywhere
Shouldn't the amp work properly just with two power tubes, another words each fuse is connected to a pair of the output tubes… The amplifier should still work just at 50 W correct?
But I get no sound at all…