HELP programming COLUMBUS

  • Thread starter Thread starter Benkenove
  • Start date Start date
Benkenove

Benkenove

New member
Hi guys...

First of all, excuse my ignorance, I'm new with the Columbus (and my very first midi equipment), so I'm a newby...

I have a Herbert, and a Columbus... ok...

I bought an standard audio cable with XLR male-female jacks...

I tried to program it like I have read (first, I push a columbus bottom, for example 01... then.. assign the channel I want to be there... for example, channel 3 + mid cut, then doble click on STORE...), I do this and nothing... U press bottom 02, and back to 01, and nothing there... ??

What is the problem ??? Should I use a MIDI CABLE instead of the suatio XLR ??? should that midi cable has the XLR jacks ??? or should I simply use midi cables in the midi out of the columbus to the midi in of the herbert to programm it ¿??

I really dont know if I'm doing something wrong... or if it's the cables... or if it's me that I'm stupid :P:P (that could be also possible even with the wrong cables :P )...

Well, no more, any help you can give me would be really appreciated ...

Ben.
 
Is the Herbert on omni mode ?

Manual at www.diezelamplification.com
 
Well, I didnt know anything about that... simply turned the amp on.. and did what I said...

Now I tried to put it on Omni mode... the leds goes on like the manual said... followed the steps to store a channel, but nothing :$ ...

Any advise/help ??? (I still think I'm a little stupid :P )

Thanks
 
Please try to switch an effect unit with the Columbus
 
You must log in or register to reply here.
Back
Top