Herbert blowing main fuse and T2 fuse 2008 model SOLVED

  • Thread starter Thread starter prsdiezel
  • Start date Start date
prsdiezel

prsdiezel

New member
Sad news, my Herbert is blowing the main fuse and the T2 fuse inside the amp. I changed the fuses with the same exact fuses. Then I changed the pre amp tubes and the power tubes and biased each set to the diezel website 65ma per set. Now it has a loud humming noise when you turn the amp off standby. All the tubes are glowing normally and I check the bias again and everything is right at 65ma. I don't know what the problem is. Guessing I would think its a Transformer cause it has that 60 cycle humming. On Standby with the volume down its a high pitch whining noise.

So now here is the problem. I read the warranty info on the Diezel site and since I'm not the original owner the warranty is void. :doh:

The amp is a 2008 model like brand new not even a year and a half old depending on what month it was made in. :aww: :no:

Please HELP!!!
 
Please search for a skilled tech and I will
support him.
 
Hey Papa Diezel, thanks for the quick reply.

What tech do you suggest? Diezel USA or a local tech here in North Carolina?
 
Papa Diezel can you tell me what you think is wrong with my Herby?
 
Just wanted to update this thread. The Herbert blowed a cap. Had it replaced at Mad Science Works with exact Ruby 22 500v and replaced all the power tubes also.

:inlove: Herberts back running and sounding better than ever. :inlove:


Thanks again Papa Diezel for the support!!!! :rock: :thumbsup:
 
You must log in or register to reply here.
Back
Top