GuitarGuyLP
Active member
The blue LED in my footswitch stopped working is there a certain brand, or device number that you use so that I can get a similar shade of blue??
Thanks
Ryan
Thanks
Ryan
PBGas
Well-known member
I believe they are:
3.5 V blue longer wire is +
+ and - are labelled on the pcb board (on the inside of the amp at least)
What you can do when you get the LED is to carefully remove it and note the orientation of the notch inside the glass bulb. Make sure your new one is on the correct side and solder it in. I had to change one on my Einstein recently and this worked just fine.
Good luck!
3.5 V blue longer wire is +
+ and - are labelled on the pcb board (on the inside of the amp at least)
What you can do when you get the LED is to carefully remove it and note the orientation of the notch inside the glass bulb. Make sure your new one is on the correct side and solder it in. I had to change one on my Einstein recently and this worked just fine.
Good luck!