Lookin for a Goldfinger 45 schematic.

  • Thread starter Thread starter MR MARCUS
  • Start date Start date
M

MR MARCUS

New member
I need a Goldfinger 45 schematic for some repair help. Bogner never responded to my requests so I thought I would try here. Thanks...
 
Does anybody have one of these? There are four 1 watt resistors burnt so bad that I can't tell what color the rings are and the bridge rectifier seem s to be the wrong one.(?) It's a 200v and that seems very low for where it is located. When I opened the amp there was a short wood screw rolling around inside of the amp. I think that might have wreaked havok on the inside of this amp. Any help would be appreciated.
 
Bogner doesn't reply on this forum and neither do his tech's. You will have to contact them direct for such information.
 
LukeCurd":2q6mzykv said:
Bogner doesn't reply on this forum and neither do his tech's. You will have to contact them direct for such information.

I did contact bogner as stated in the OP.
 
MR MARCUS":31v81d3q said:
LukeCurd":31v81d3q said:
Bogner doesn't reply on this forum and neither do his tech's. You will have to contact them direct for such information.

I did contact bogner as stated in the OP.

Fix it, sell it and avoid bogner for bad customer service.

I was just trying to help.
 
Schematics are not openly released. Contact Charlie at Bogner for issues, he will gladly help you, always have done whatever was needed for me. Or listen to JerkCurd and sell it..... Not serioius about listening to LukeTurd....
 
Good to see ya back on the forum, Tim. Was wondering where you've been, saw your post a month back...
 
se7en":13apqikt said:
Good to see ya back on the forum, Tim. Was wondering where you've been, saw your post a month back...

Thanks se7en, nice to see you and a few other friends still on here!!
 
Back
Top