Marshall 4x12 straight dimensions?

  • Thread starter Thread starter tweed
  • Start date Start date
Digital Jams":e7fa3 said:
Make sure you look for INSIDE measurements.
Click to expand...

don't have one to look inside of. I'm hoping someone here has looked inside one and can share some insight.
 
Well I can measure and snap some shots of my mojo Aiken if you want to get you rolling at least with a parts list, I believe the mojo is the same size.

Do not skimp on the wood or your hard work is out the window imo.
 
Digital Jams":796b4 said:
Well I can measure and snap some shots of my mojo Aiken if you want to get you rolling at least with a parts list, I believe the mojo is the same size.

Do not skimp on the wood or your hard work is out the window imo.
Click to expand...

Thanks bro! I got a couple sheets of 13layer voidless birch on a shelf begging for the saw. ;)
 
exterior dimensions 29 3/8" h x 29 7/8 w x 14 d. w/o casters.
baffle opening 26 3/8 h x 26 7/8 w
can't measure the baffle depth w/o removing the grill cloth.. however the baffle angle appears to be three degrees. hope that helps. :)
 
1big1":29936 said:
exterior dimensions 29 3/8" h x 29 7/8 w x 14 d. w/o casters.
baffle opening 26 3/8 h x 26 7/8 w
can't measure the baffle depth w/o removing the grill cloth.. however the baffle angle appears to be three degrees. hope that helps. :)
Click to expand...

Thanks!!!! :thumbsup: :rock:
 
His measurements are correct, but I can't comment on the baffle angle. Just remember that Marshall uses 11ply birch not 13. So you either will have to match the outside or the inside. You can't match both.
 
you're welcome. if it also helps you the offset measurement of the grill cloth measured from the front of the cab at the cloth.. not the piping.. bottom 7/8" top 1 7/8".
i used an angle inclinometer to measure the angle.. so it should be close.
 
Theres lots of good stuff there, thanks Kage - very cool.
 
You must log in or register to reply here.
Back
Top