Marshall 9005 in MONO

[jingesson]

Ha i need some help.Just bought a Marshall 9005 tube amp with the 9001 preamp.In the manual i saw i can use it in mono mode and only use channel A?But didnt found any information how i connect channel B?Or did i just leave channel B empty?I bought an 4x12 cabinet i shall have to this amp and i want to use it as an 4x12 mono,.An alternate is to use it in stereo with 2x12 to each channel.
Im very thanksful if anyone could help me

Jonas

 

[ke2]

http://www.google.com
http://www.google.no/search?hl=no&q=mar ... nual&meta=
http://www.drtube.com/marshall.htm
http://www.marshallamps.com/downloads/f ... %20hbk.pdf

I`d use the channel A input, and run the cab in stereo. If you have a 16 ohm cab, set each impedance selector to 8 ohms. If the cab is 8 ohms, set the selector to either 4 or 16. (the back panel of your cab should tell you how is runs when in stereo mode. It`s usually 2x4 ohms.


Håper det hjelper,
Knut E

 

[squealie]

I ran my 9005 for years just plugging into A and going out A.... leaving B on standby.

Not sure if that's the best way to do it... but it worked fine.

 

[Everlone]

I ran my 9005 for years just plugging into A and going out A.... leaving B on standby.

Not sure if that's the best way to do it... but it worked fine.

That's what I did too.