tfridgen
Well-known member
May be a stupid question, but what's the best way to drive a slave power amp with the JVM 210h?
racerevlon
Active member
On the rear of the head, there's a set of jacks labeled "Power Amp Insert/Serial Loop" and the left jack says "Preamp out/Send." Connect that to your slave power amp and you're good to go.
Cheers,
Cheers,
Gainfreak
New member
racerevlon":2dltwa0s said:
This ^
Take a 1/4 Instrument cable and plug it into the Preamp out/Send on the back of the JVM. Send that to your effects (if you want) and then to a slave amp or poweramp. DONE:
tfridgen
Well-known member
Excellent, just what I was hoping to hear. I'm used to Mesa's with the slave out.