raymitchell
Member
Hey guys!
So, thinking about working my way back into a Boogie Mark Series head, and, this time I think I'm gonna go with a JP2C. Having said that, I was wondering if anyone here has any experience using the JP2C with the CabClone active BUT, with speaker set to 'off' and then using the slave out of the JP2C to feed the Axe Fx rather than a load box (Weber, Two Notes, etc) with a line level tap on it.
I want to use the JP2C in 4CM/mode and be able to flip between the JP2C and Axe Fx amp models. From the Axe Fx I'll be going out to a stereo power amp and on to two 4x12's.
From my past experience of slaving a IIC+ in to either a Boogie 50/50 or Mesa 2:90, the slave out sounded great in the sense that it captured the whole sond of the amp (includes the 5 band graphic eq in the signal).
Basically, I wanna do 4CM but, rather than use the JP2C's fx loop on the return, I wanna use the slave out so that the signal being returned to the Axe Fx includes the 5 band graphic in the signal.
With the built-in CabClone, that gives me an onboard load resistor, which, shoud, free me up to use the slave out to send to the Axe Fx, yes?
Thanks in adavance for your help!
Ray
So, thinking about working my way back into a Boogie Mark Series head, and, this time I think I'm gonna go with a JP2C. Having said that, I was wondering if anyone here has any experience using the JP2C with the CabClone active BUT, with speaker set to 'off' and then using the slave out of the JP2C to feed the Axe Fx rather than a load box (Weber, Two Notes, etc) with a line level tap on it.
I want to use the JP2C in 4CM/mode and be able to flip between the JP2C and Axe Fx amp models. From the Axe Fx I'll be going out to a stereo power amp and on to two 4x12's.
From my past experience of slaving a IIC+ in to either a Boogie 50/50 or Mesa 2:90, the slave out sounded great in the sense that it captured the whole sond of the amp (includes the 5 band graphic eq in the signal).
Basically, I wanna do 4CM but, rather than use the JP2C's fx loop on the return, I wanna use the slave out so that the signal being returned to the Axe Fx includes the 5 band graphic in the signal.
With the built-in CabClone, that gives me an onboard load resistor, which, shoud, free me up to use the slave out to send to the Axe Fx, yes?
Thanks in adavance for your help!
Ray
