billytone
New member
I have been using the GT-10 (effects only using the four cable method) with the Renegade 212. The GT-10 has the ability to switch channels on the amp using a mono plug into the footswitch input of the amp from the GT-10. However, the channel switch and boost are on a stereo plug. So I can switch the amp channel but not the boost. This has worked fine as I simply use a boost on the GT-10 as needed. I discovered a neat little trick last night as we were setting up for a gig. I turned down Main 1 all the way to zero so I could slowly come up to see how it sounded in the room and to my surprise the amp was not silent. When I looked at the knobs I noticed Main 2 was not at 0 so I turned it down and the amp was silent. Which means I can mix Main 1 and Main 2 or just use Main 1 or Main 2 as needed! Here I thought I had lost the ability to use Main 2 at all. I prefer an even mix of the two mains so far. I am continually amazed at the flexibilty, tone and build quality of the Renegade.
Billy
www.cryofstones.com
Billy
www.cryofstones.com