S
sonicgraffiti
New member
Hi all. First post, noob member. I picked up on Egnater amps last summer when I got my first Rebel 20. Fell in love with the very first note that I played out of it. So, naturally not satisfied with one channel went out to pick up a Renegade Head, which appears to be a 2 channel version of the same thing, with a few more whistles and bells on it. Great stuff!
I ordered this amp used to be shipped from a Guitar Center out of Indiana, and just received it yesterday around the Detroit area. Took it home, put the tubes in, and fired her up! Loved what I was hearing...for the first time, MY amp was singing along with the Les Paul I've been playing since 1997. I was in heaven.
Then it stopped! Completely powered down.
Then after about 5 minutes, it slowly turned itself back on.
I may be new to valve-based amplification (on an ownership level), but it doesn't take a rocket scientist to know that this was probably an over heating issue with the tubes. So I take the back vent off and notice that the internal fan is disconnected...the wire to it is completely free. Well, I could not find the place where it was supposed to connect, even after removing the front grill piece.
So a couple of questions...first, where does this fan connect? And where does one find replacement parts for a couple of the jacks on the amp? The main Input jack, and the Reverb Input jack on the back, appear to be missing the washer, and the small nut that holds them on...
Thanks for any help.
I ordered this amp used to be shipped from a Guitar Center out of Indiana, and just received it yesterday around the Detroit area. Took it home, put the tubes in, and fired her up! Loved what I was hearing...for the first time, MY amp was singing along with the Les Paul I've been playing since 1997. I was in heaven.
Then it stopped! Completely powered down.
Then after about 5 minutes, it slowly turned itself back on. I may be new to valve-based amplification (on an ownership level), but it doesn't take a rocket scientist to know that this was probably an over heating issue with the tubes. So I take the back vent off and notice that the internal fan is disconnected...the wire to it is completely free. Well, I could not find the place where it was supposed to connect, even after removing the front grill piece.
So a couple of questions...first, where does this fan connect? And where does one find replacement parts for a couple of the jacks on the amp? The main Input jack, and the Reverb Input jack on the back, appear to be missing the washer, and the small nut that holds them on...
Thanks for any help.
