Renegade OD section not working

  • Thread starter Thread starter SCkindaguy
  • Start date Start date
S

SCkindaguy

New member
Hello all - I was playing a gig this past Friday when I got to the venue plugged in my Renegade head and strummed a few clean chords. Everything sounded fine. Upon switching to the overdrive channel, my output was completely silent. The channel switches, but there is absolutely no output. Any ideas??

I rely on the Renegade OD section for a huge portion of the tone for the band I play in and as we were on the road that night and had a gig last night, tonight, and tomorrow, I stopped at the local Guitar Center and picked up a Tweaker 15 until I can get my Renegade figured out. I needed a backup head anyway, right? :-)

Any thoughts as to why that section is not working would be greatly appreciated!
 
Check your V3 and V4 preamp tubes to see if one of them went bad. those two slots are in the OD channel.
 
Swapped out the tube in V4 slot and that did the trick. Thanks for the reply!!
 
You must log in or register to reply here.
Back
Top