renegade ohm selector help

  • Thread starter Thread starter baker508
  • Start date Start date
B

baker508

New member
hello there,i have a renegade 212 combo i would like to run through my line 6 spider 412 cab, not sure where to set ohm selector switch?any input would be appreciated thank you.
 
Does the spider cab say what the ohms are anywhere near the jack? If so all you need to do is make sure they match. For example set the renegade to 4 ohms and plug into the 4 ohm input on the cab.
 
Check your manual there should be instructions on how to run the extra cab safely.
 
OK,thank you. it does have ohm # by input jack so i can match . got the amp used i don't have a manual.
 
I think the manual is available on the Egnater website for free download.
 
You must log in or register to reply here.
Back
Top