Renegade settings thread

  • Thread starter Thread starter bartmcartman
  • Start date Start date
B

bartmcartman

New member
Anyone wish to share their settings? Presence, density, tight, bright, etc.?
 
I'd go with low volume settings and high volume settings too. This is two different amps at lower and higher volume settings (as many are).

I'll take a look at where my settings are and try to remember to post some here.
 
master is at 9-10 oclock and i adjust channel volume from there. presence 2-3 oclock, density4 oclock, bass, mid treble all at 3-4 oclock. that is for the distortion channel. tight and bright on.
 
Right now with WGS ET65's my clean is 65w, deep, bright, gain at 10:00, Bass at 3:00, mids at 10:00,treble at 11:00, tube mix at 12:00, volume at 11:00
Drive channel, 65w, Tight, Bright, Gain at 2:00, Bass at 3:00, Mids at 10:00, treble at 10:00, tube mix at 12:00, volume at 10:00. Density at 1:00, presence at 11:00, main at 12:00
 
on the second channel, turn up all eq (BMT) all the way. then set presence and density to taste.
 
These are my home settings, Clean gives a nice Mayer strat tone, turn up the mids and lower the treb for a good tele tone. Grit is my main tone, works well with my overdrives and with my Red Muck I get a great Gilmour tone, turn to 6L6 gives the same sustain but not a Pink sound. Ch-2 gives a great Marshall tone, kick in the OCD to push it for solo's. Ch-1 has Main 2 on all the time and always off on Ch-2.
Master.jpg

Ch-1Clean.jpg

Ch-1Grit.jpg

Ch-2.jpg

The Vid is Ch-1 playing with OCD and Red Muck pedals, 6L6 side and EL34, late at night very quiet, but shows how good the Renegade is, I love it.
http://youtu.be/wdzCXO47nVI
Hope that helps Bart.
 
Bump.

Curious to see more of these. I've got some cell phone pics somewhere with my settings just in case the knobs get turned during transit to a gig. I'll have to dig them up.

Also, thinking about ordering some backup tubes to have in case one gives up the ghost. Any recommendations on a good set or where to start looking? Love the crystal cleans this amp is capable of, but could use more oomph out of channel 2 at times.

Thanks in advance for any advice.
 
There is "suggested settings" section in the owner's manual. These can give you some good starting points. If you don't have one, you can download it at egnateramps.com
 
Back
Top