Signal Splitter

  • Thread starter Thread starter Ben Waylin
  • Start date Start date
Ben Waylin

Ben Waylin

Banned
Well-known member
What are you men using to run a guitar signal into two amps ?

Apologies if this has been discussed before.
 
harddriver said:
The Metropolous Headmaster looks to be the best I've seen on the market.
Click to expand...

I should have specified.. I don't wanna use two heads into one cab.

I want to run the guitar into two heads and have two line-level signals to mix in the DAW, using reactive loads I already have.
 
PLX said:
I should have specified.. I don't wanna use two heads into one cab.

I want to run the guitar into two heads and have two line-level signals to mix in the DAW, using reactive loads I already have.
Click to expand...
George is playing one guitar into the headmaster then uses the headmaster to switch between the two heads. The headmaster can be used to switch two heads in to one cab or one guitar into two heads from what I have read and learned about it.
 
I don't know if the headmaster can combine the signal to feed two amps at the same time if that it what I gather.

I would imagine just an ABY pedal where you can combine both outputs at the same time. I think Morely had one that Lynch supposedly used to feed to three amps it's called the Tripler. That should do what you want plus it says GEORGE LYNCH on it.:2thumbsup:

https://reverb.com/item/2048964-morley-tripler-george-lynch-selector-combiner-guitar-effect-pedal
https://reverb.com/item/61955922-morley-aby-switch
 
harddriver said:
I don't know if the headmaster can combine the signal to feed two amps at the same time if that it what I gather.

I would imagine just an ABY pedal where you can combine both outputs at the same time. I think Morely had one that Lynch supposedly used to feed to three amps it's called the Tripler. That should do what you want plus it says GEORGE LYNCH on it.:2thumbsup:
Click to expand...
rW3PPOo.jpg

Yeah, I didn't know the correct name for it when I started the thread, but I been lookin' at ABY pedals and I think that's all I need to do what I wanna do.

That guy's description for the Morley Tripler reminds me of the time I saw some dude tryin to sell a used fleshlight on Craigslist.
 
I use the Keely Framptone Three Banger . So I have 3 on any time or off when need . Typically Hermanson, Wizard , and a Diezel hooked up
 
I had the EHX switchblade and there was a groundloop that I couldn’t fix. I ended up getting a Lehle ABY with the p-split to isolate each preamp. Bam. No noise. There are other unit but this works for me.
 
alund said:
I had the EHX switchblade and there was a groundloop that I couldn’t fix. I ended up getting a Lehle ABY with the p-split to isolate each preamp. Bam. No noise. There are other unit but this works for me.
Click to expand...
That's cool.

Looks like it uses miniature transformers to isolate the signal lines.
 
PLX said:
That's cool.

Looks like it uses miniature transformers to isolate the signal lines.
Click to expand...
Yes. Needed the p-split to create a 3rd isolation. Used two heads in the past and worked just as good as with my preamps and respective power amps
 
Slight over-kill for what I do, but to my ears is the most transparent I've found. I'm happy enough with it to look no further.

Been running a Matchless Laurel Canyon and Lightning on smaller stages with it.

 
You must log in or register to reply here.
Back
Top