So I just biased my Herbert

[realityescapes]

And the inner pair of 6l6s was at about 110ma. . I had been using it for a while before I knew it was this far off. I'm assuming that that pair of tubes being run so hot would probably need to be replaced or checked out? Amp sounds good I just want to make sure it's a hundred percent. What would you do. Thanks

 

[duesentrieb]

Set it to 70mA (the pair), check after you've played for an hour, if it is still in that area, keep it. If not - replace it.

 

[realityescapes]

Thanks Olaf!!!