D
DSS3
Active member
Selling my Monomyth modded Marshall 1987x from 1997
Full album:
Has the following additional switches/knobs:
Important note: UPS did a number on this guy in shipping to me a few years ago. The headshell completely separated at the bottom plate seams. The amp thankfully came intact and with no problems - this is the most common type of break with these headshells. I re-attached with woods screws and it’s more stable than it was before, but the tolex shows the burst seams on the bottom. If I were to gig with it I’d probably replace the headshell, but I only used it in a studio setting and had no misgivings about it.
SOLD on reverb
Full album:
Has the following additional switches/knobs:
- Blood (extra gain)
- Black Sun (resonance knob/nfb toggle)
- Rise and Fall switches (input bright cap/pre-eq)
- Top right input disconnected
- Loudness I as master vol
- Loudness II as gain control
Important note: UPS did a number on this guy in shipping to me a few years ago. The headshell completely separated at the bottom plate seams. The amp thankfully came intact and with no problems - this is the most common type of break with these headshells. I re-attached with woods screws and it’s more stable than it was before, but the tolex shows the burst seams on the bottom. If I were to gig with it I’d probably replace the headshell, but I only used it in a studio setting and had no misgivings about it.
SOLD on reverb
Attachments
Last edited: