SS rec plug swap—is rebias needed?

  • Thread starter Thread starter tallcoolone
  • Start date Start date
I think your ok, I did it in a jtm 45 and a bogner metropolis and never rebiased the jtm the bogner was EL 84 fixed bias
 
You should be fine but it doesn’t hurt to check. I didn’t need to on mine. If you’re looking to just tighten the bottom a little they’re perfect.
 
I've been curious about this on my DS40 so I just tried it....

At 120V, Tube to SS rectifier. Plate went from 453 to 467. Bias current from 41 to 48.
 
 
Back
Top