switching pots for midi board

  • Thread starter Thread starter ssegura
  • Start date Start date
S

ssegura

New member
Question for Peter--I recently had my #2 button malfunction on me, and only had the board 7months how can I fix or replace it. Looks like some brass pin that holds the assembly together came out one side of the switch. They look well built but this one surely can be found at your local hardware store. Anything will be helpful :cry:

Saul :m17:
 
Which amp do You have ?

Do speak about switches on the front
or jacks on the rearside ?

Thanks,

Peter
 
Sorry for not being specific, the midi board itself (columbus) the #2 on the foot switch. The foot switch clicked and then it just stop working, like it was jammed or stuck in position. I opened the bottom of the foot switch and saw what looked like a long brass pin that must hold the spring or assembly of the switch together. It looks to me after looking at the others that it was not flatten on the end so it would not slide out. But in my case it was all the way out and was not flatten on that one if this makes any sense to you. Sorry not good with terms of the parts.

Saul :m17:
 
Aaaaaaaaaaaaaahh,

You need a single footswich for the Columbus.

Please send an email with Your address to:

peterdiezel (at) diezelamplification (dot) com

Thanks
 
You must log in or register to reply here.
Back
Top