Tweaker Cab Linking Question?

  • Thread starter Thread starter tacomatrd
  • Start date Start date
T

tacomatrd

New member
I just got the Tweaker head and two 112 cabs and I love this thing! I always used a combo amp so the ohm's and linking cabs is all new to me. I hooked the one cab into the main jack in the back of the head as it is shown in the manual but, I have another 112 cab to hook up and did not want to proceed with out some help :confused: . I was told that I should run the next cable from the other 1/4" input from the cab that is hooked to the head now to the 1/4" jack in the second cab. Is this correct or should the second cab go into the extension jack in the back of the head? I was also told to switch the impedance to 8ohm's with two cabs hooked up. Is that the correct setting? I know that these are basic questions and I am sorry for this but I am new to these kind of set-ups any help would be greatly appreciated. :D
 
Check out my thread, I'm having the same problem.

The only speakers I've owned in 30 years with two sockets have been stereo ones, since these are mono with single speakers I have no idea which is best ??
For now I'm using both speaker jacks from the head to the induvidual cabs ;)
 
You can hook up the speakers either way. All the jacks are wired together in parallel. If you have one 16 ohm cabinet connected, set the ohm switch to 16 ohms. If you have both 16 ohm speaker cabs hooked up, set the switch to 8 ohms.
:rock:
 
You must log in or register to reply here.
Back
Top