Twin Jet tube layout diagram???

[moronmountain]

Does anyone have a copy of this, or know where I can get one? The Bogner site used to have on for the regular Uberschall, but I don't see it any longer. I'm just curious which spots are used for each gain stage, phase inverter, blah blah blah on each channel, and if any of the spots prefers a balanced triode tube. I'm assuming Bogner uses Chinese 12ax7's stock, and Sovtek KT88's for the power section????? Any help/info would be greatly appreciated.

Stimpy

 

[leib10]

It's the same, except V4 is for Channel 1. And yes, those are stock tubes.

 

[SLOgriff]

Here ya go!

V1: Input tube for both channels, 12ax7
V2: High gain channel, 12ax7
V3: High gain channel, 12ax7
V4: Clean channel 2nd stage one triode only, Twin Jet Semi Clean 2nd and 3rd stage, 12ax7
V5: Loop, 12ax7
V6: Phase Inverter, 12ax7
V7 through V10: Power Tubes,Uberschall EL34, Twin Jet KT88

 

[Ventura]

Here ya go!

V1: Input tube for both channels, 12ax7
V2: High gain channel, 12ax7
V3: High gain channel, 12ax7
V4: Clean channel 2nd stage one triode only, Twin Jet Semi Clean 2nd and 3rd stage, 12ax7
V5: Loop, 12ax7
V6: Phase Inverter, 12ax7
V7 through V10: Power Tubes,Uberschall EL34, Twin Jet KT88

And aren't there two cathode follower positions that need to be heeded here for high voltages? I think V3 and V5 or V4 and V5, not sure, please advise.

 

[moronmountain]

Thanks for the info. So was I correct on the Chinese pre's and Sovtek kt88's thing? What tubes, specifically output tubes has anyone tried in their TJ's that did well? Must be of the KT88's type.