
napalmdeath
Well-known member
Custom ordered in this color scheme from Peter Rutter last year, it's a 2024 that incorporates the compression knob, vs older models that had it as an internal trimpot you had to take it apart to get to. No introduction needed, many of you know what this pedal is all about.. $130 Shipped PPFF. NO TRADES.
Features:
*LEVEL - controls the output of the Dragon
*DRIVE - sets the gain of the drive circuit
*COMP - sets the compression ratio of the drive circuit (clockwise = even harmonics, counterclockwise = odd harmonics)
*HPF - varies the frequency cutoff point of the high pass filter(s), from 33 Hz to 2.2 kHz.
*LPF - varies the frequency cutoff point of the low pass filter(s), from 330 Hz to 22 kHz
*6dB/12dB - toggles between first-order (6dB) and second-order (12dB) filters. The middle position sets the HPF @ 12dB and LPF @ 6dB.
*BUFFER/TRUE - this internal switch selects between buffered and true bypass switching.
*LED - This internal trimpot affects the brightness of the LED indicator.
*DUALMODE - Wait 3 seconds and press tap + tap + hold for 3 seconds with the footswitch to activate or deactivate momentary mode.
*POWER - Accepts the industry-standard 2.1mm pin, 5.5mm barrel, negative-tip power supply. Accepts 9V up to 18V.
Features:
*LEVEL - controls the output of the Dragon
*DRIVE - sets the gain of the drive circuit
*COMP - sets the compression ratio of the drive circuit (clockwise = even harmonics, counterclockwise = odd harmonics)
*HPF - varies the frequency cutoff point of the high pass filter(s), from 33 Hz to 2.2 kHz.
*LPF - varies the frequency cutoff point of the low pass filter(s), from 330 Hz to 22 kHz
*6dB/12dB - toggles between first-order (6dB) and second-order (12dB) filters. The middle position sets the HPF @ 12dB and LPF @ 6dB.
*BUFFER/TRUE - this internal switch selects between buffered and true bypass switching.
*LED - This internal trimpot affects the brightness of the LED indicator.
*DUALMODE - Wait 3 seconds and press tap + tap + hold for 3 seconds with the footswitch to activate or deactivate momentary mode.
*POWER - Accepts the industry-standard 2.1mm pin, 5.5mm barrel, negative-tip power supply. Accepts 9V up to 18V.
Last edited: