Vintage marshall fuse holder

[Cap217]

I recently bought an old super lead and went to check the fuses and the one fuse holder snapped. I assume it was broken and glued and when I went to tighten it, it snapped.

I have another super lead that’s been modded so I wanted to take that fuse holder out because it matches and then put a new one in the modded amp. But I’m not sure how the old ones are removed then installed again. Can anyone help? Do they snap or screw? There is a brass ring that goes around the outside panel.

Pic of broken part. Abs pic of the modded amp I’d take one from.

 

[Fret-Shredder]

https://www.amprepairparts.com/fuseholders.htm
Is the first one on that page what you need?

 

[Cap217]

https://www.amprepairparts.com/fuseholders.htm
Is the first one on that page what you need?

Thanks but not the same.

 

[Fret-Shredder]

Thanks but not the same.

Question is still do the screw on to tighten or do they snap? I dont see threads on my broke piece.

Sorry man. They are my go to for Marshall parts.

 

[Cap217]

Ok, I figured out how they install or come out. Its just 1 piece. The way mine broke it seemed like it might screw on and tighten from both sides.