Wall of Sound not working

  • Thread starter Thread starter Manimal91
  • Start date Start date
M

Manimal91

New member
So I just bought the torpedo captor 16 to use it for silent recording of my jcm 800.

My rig chain goes like this:

Guitar to Amp to Captor to Focusrite scarlet 2i2 via XLR cable.

The only sound I get is the raw signal which sounds really bad. I try both guitar and bass pre built analogue cab sims and nothing happens. When I open WoS in Cubase 10, I still dont get any sound from the cabinets although I get the effects like reverb.

What gives?
 
Are you using loopback on your interface? From your description, you might have the input routed to the output for monitoring. You need to mute or disconnect the input monitoring on the audio interface (on the Focusrite software)
 
You must log in or register to reply here.
Back
Top