WTB: Mesa Mark III Head Shell

  • Thread starter Thread starter DSS3
  • Start date Start date

To buy, sell, or trade in this section, you must have at least 50 posts and have two-factor authentication enabled.

D

DSS3

Active member
Haven't been able to find one on Reverb or eBay after a few months of looking, so I figured I would put up a thread here before biting the bullet on a custom build head shell.

I have an early Mesa Mark III (black dot) combo that I'd like to get a standard black tolex headshell to load the chassis in. Not picky on quality or room for the reverb tank, just looking for the standard black tolex Mesa shell.

Anyone have a spare they'd part with?

*edit* I don't need suggestions on where to get a new one made. I am well aware other forum members make them and have already contacted a few for quotes. I am looking for an OG black tolex one here first.
 
Last edited:
DSS3 said:
Haven't been able to find one on Reverb or eBay after a few months of looking, so I figured I would put up a thread here before biting the bullet on a custom build head shell.

I have an early Mesa Mark III (black dot) combo that I'd like to get a standard black tolex headshell to load the chassis in. Not picky on quality or room for the reverb tank, just looking for the standard black tolex Mesa shell.

Anyone have a spare they'd part with?
Click to expand...
I know there are many builders that make these; but I believe Mesa still sells them direct if you need one.
 
there are some guys on this site that do them. Search this forum and you will see a name being recommended. Avoid Zilla on this one(they do good work but they screwed up my Mark iv headshell and I had to buy one from Mesa)
 
Thanks guys but I am well aware of where to get a new one if I want to go that route, and cited in my original post that I wanted to check here before ordering a new one.
 
You must log in or register to reply here.
Back
Top