Coma
New member
Just picked up a used Ironball. Killer amp, love it, but the FX loop is acting up.
Plugged in a Boss NS2 and it causes more squeals than it removes.
Plugged in an MXR 10-band EQ and the LEDs on it started flickering. Looked around online and according to MXR, this is what happens when the input signal is too hot and the pedal starts to clip.
I've tested both pedals in other amps and they work fine there, so they're not faulty.
My guess is the signal coming through the FX loop is way too hot.
I've tried contacting ENGL but haven't had any response so far.
Anyone recognise this issue? What can I do about it (short of sending it to a tech)?
Plugged in a Boss NS2 and it causes more squeals than it removes.
Plugged in an MXR 10-band EQ and the LEDs on it started flickering. Looked around online and according to MXR, this is what happens when the input signal is too hot and the pedal starts to clip.
I've tested both pedals in other amps and they work fine there, so they're not faulty.
My guess is the signal coming through the FX loop is way too hot.
I've tried contacting ENGL but haven't had any response so far.
Anyone recognise this issue? What can I do about it (short of sending it to a tech)?