How to attach feet to pedalboard?

[guitarnerdswe]

Hi guys!

Does anybody know how to attach feet to a pedalboard, so that you can't see the rivets from the top of the board?

Like this:

Are they feet screwed, or perhaps rivets are used? But how do you hide the rivets if you use them?

Thanks

 

[cujo]

They are probably counter sunk n they are under that blk laminate

 

[Ancient Alien]

Very simple. Screw them in from the bottom.
If the board is MDF or particle board, pre drill the holes a drop smaller than the screw shaft, not the thread size.
Make sure to use "wood" screws, not fine thread.
To add a little security, I put a drop of silicone on the back of the feet.
Just make sure you use the proper length screws. 1/8 inch shorter than the thickness of the board.

 

[cujo]

Or some liquid nails. Those feet like to rip right off.

 

[Ancient Alien]

Use this type of amp feet...they will not rip off.
And I would use 6 of them if the board is longer than 24 inches for center support.
http://www.tubesandmore.com/search/node/rubber%2520feet


I personally use this type for all the pedal boards I have built.
They are low profile, very dense, come with a washer for screw support
http://www.tubesandmore.com/products/P-H9107