Need assistance setting up Axe fx into poweramp and cab

E

ElectricTurkey4369

New member
I'm switching from FRFR and need to be reminded of how to make these connections. My buddy lent me his American Audio VLP300 while I look into buying a matrix.
My port city cab is wired at 8 ohms, and there's stereo/mono switch on the back. I don't wanna fry anything, so how should I run the amp into the cab? thanks
 
The switch on the back shows that I can only run mono at 4 or 16, unless I'm not understanding the back plate properly. I have it plugged into 4 from channel A, bridged Mono mode, but I'm not getting any sound? there's input sensitivity switches, could those be the case?
 
ElectricTurkey4369":3aw5o9be said:
The switch on the back shows that I can only run mono at 4 or 16, unless I'm not understanding the back plate properly. I have it plugged into 4 from channel A, bridged Mono mode, but I'm not getting any sound? there's input sensitivity switches, could those be the case?
Click to expand...

Oh ok, didnt realize you didnt have the 8 ohm tap.
 
You must log in or register to reply here.
Back
Top