Search results

There were only a few Hell Razors that went out without the updates per Rick. Anything from 2023 has the updates

All coupling caps are stock amp acceptthe two coming off of the added pretube.The 2 Yellow couplers are 10uf. They were 22uf. The blue cap I think is 1.1 or so

Jason is a standup guy and legit. Its been awhile since I dealt with him but he has a great rep. I don't know of anyone who had issues with him in regard to Mark.

Assholes. On another note. Headshell is ok. I would open it up and take a look. That chassis bolt might not be a big deal, although chassis might be bent. No sound- could be a tube. Those amps do not use good support legs on the trannys, at lest they didn't in the initial run. Mine was bent a...

Isn't this a Memran Marshall?

She used to call them my Mistresses. One day some years back, I got caught walking in with a new amp. I said Honey can you hold the door for me. The amp badge was facing out. She looked at it and said "They fucking have names now"! It was a Carol Ann lol

You're a smart Man for marrying that one.

Can I get a 415 bump lol

Sometimes you have to remove or loosen the bolts on the transformer to bend it straight, especially if it has mounts. If its under the board its a pain in the ass because you have to lift the board on some amps to get at the bolts. That does sound high if he didn't replace your tubes.

Yes 4 amp in the mains and 2 amp in the HT

You might want to lower that because the fuse is not doing it's job, which is to protect your transformer. 10 amp is way to high. If you have a tube voltage arc you will blow a transformer rather than the fuse. It happened to my Wizard. You are free of course to think what you wish. It's your...

Its been awhile since I did it. I only cloned it and did it as I went so no schematic or layout. I am an awesome copycat lol plus I know enough to be dangerous. Been soldering and tinkering for 25 years

Lowering the value of those caps does not affect the stock tone one bit. The added circuitry is only in the circuit with the pot pulled. With the pot in all added circuitry is completely bypassed. Mine has a huge tight bass with my bass pot at 11:00.

One of my favorite mods. I owned two of them and cloned one into an 89 JCM800 with a few tweaks and its an awesome amp. They go from clean to mean with little volume drop because of where the circuit is placed after the stock gain stages before the cathode follower. I even constructed the same...

If I used effects would I play better? To me it sounds too polished and too easy and fake lol. May as well just use a modeler.

Tough crowd LOL. I enjoyed Tim in a small venue when I saw him five years or so back.

Unfortunately you have zero recourse. Sorry you are out the money. Sucks but shit does happen.

Yes, The OT sees four tubes as two pairs. Two primary leads come from your OT, one to each inner power tube socket. The outer tubes are connected to the inner tubes. Make sure to take a reading on your screen resistor for that tube that popped. You may have an open or dead resistor in that spot.