I am finally going to remove the .047uf 600V death cap off the polarity switch in my 72 Marshall

[harddriver]

Not too shabby! I see a few interesting changes in that one. The use of epoxy... you sure that was done at the factory?

I actually prefer the lighter, tan boards! They look cooler to me and easier to clean up since you can see where all the gunk is haha.

As far as the '71 goes, plans haven't been set in stone yet.

Here's a74 that has that same silcone rtv/hot glue on the components like my 72...Original? dunno

 

[FourT6and2]

Here's a74 that has that same silcone rtv/hot glue on the components like my 72...Original? dunno

Yeah but that's a PCB, not a turret board, and some of the parts that are glued are not original. So that glue was added later, like with that janky internal strain relief on the mains. The hot glue on that tag board/strain relief matches the hot glue on the PCB. I doubt that was done at the factory.