SQUAREHEAD
Well-known member
I have the plug in with the window, but I need this part…
Be great to find one?
Be great to find one?
P
PatF
Active member
I have one. Out of a '75. I don't have the plug. Trade?
SQUAREHEAD
Well-known member
Sure.?
Greazygeo
Well-known member
No one makes them. I went with a three way rotary pot for mojotone for two of mine. Those original deals are too sketchy to trust for me.
SQUAREHEAD
Well-known member
Still need one?
C
chumbucket
Well-known member
You're probably better off just replacing it with the reissue style. Sometimes, the plug won't make contact and it could smoke your output transformer.
https://www.mojotone.com/Marshall-Impedance-Selector-Switch
https://www.mojotone.com/Marshall-Impedance-Selector-Switch
psychodave
Well-known member
These are slightly bigger than the original chassis hole in the amp. You have to use a dremel and make the hole bigger. I even tried to shave down the selector switch and it fell apart before fitting into the chassis hole.
Greazygeo
Well-known member
https://www.mojotone.com/Mojotone-Impedance-and-Mains-Selector-Switch
This is what I used for both my ‘69’s. Made a plate to mount where the stock switch mounted. Drill a hole for the new pot and good to go.
This is what I used for both my ‘69’s. Made a plate to mount where the stock switch mounted. Drill a hole for the new pot and good to go.
alund
Well-known member
I got an early plexi a number of months back and the ohm selector cut in and out…. I immediately shut the amp down and brought to Todd Sharp in Nashville. Needless to say I was worried for a few days.. fortunately the transformers were ok and it was the above problem. They just installed a new one. I’m not taking the chance.