I recently acquired a 2290 with an 0144 controller and did not realize that the controller has a hardwired Euro plug and takes 220V.
It's clear that the transformer was soldered along with the components on the PCB in what was likely a wave solder, but the power leads as well as a jumper wire were done by hand after the fact. This has me wondering if the same transformer was used for both the Euro market and US with the difference being the input voltage and possibly the omission of the jumper. I can't find any info on the transformer (Tradania TD 3706) but the ID sticker makes it look like there are two 110V primaries and four 9V secondaries
If anyone has a schematic, it would be tremendously useful as I haven't been able to fine one and getting it from TC has been fruitless
It's clear that the transformer was soldered along with the components on the PCB in what was likely a wave solder, but the power leads as well as a jumper wire were done by hand after the fact. This has me wondering if the same transformer was used for both the Euro market and US with the difference being the input voltage and possibly the omission of the jumper. I can't find any info on the transformer (Tradania TD 3706) but the ID sticker makes it look like there are two 110V primaries and four 9V secondaries
If anyone has a schematic, it would be tremendously useful as I haven't been able to fine one and getting it from TC has been fruitless